Block Stropping Fixture directions (Cont'd):

"So, here is my idea for beckets with a simple modification.
It is not on the photos that are shown in the Photos Section, because I hadn't thought it up yet.

Picture this. In the center of the 1/4" tongue and extending from it's top surface , down to the base radius that forms the tongue, I will cut a vertical "V" that will hold a "Becket Pin". It will be on both sides of the tongue so beckets can be formed on either end of your block(s). There will be a strap going across the tongue with two screws to secure the Becket Pin Clamp.

And there you have it!

Yes, you have to make a dedicated fixture for each block , but so what? With time, and wear and tear, from aggravation and frustration solved, you will wonder how you go along without it."